NOTE:It is recommended that a good perforation guide be included in the printing plate.
STEP 1: Make certain that the impression cylinder is clean and free from oil or grease.
STEP 2: After positioning image on sheet,transfer image to the impression cylinder.
STEP 3: Cut off the amount of Perfect Perf to rule required and remove the paper backing to expose the adhesive coating.
STEP 4: Following the guideline ,apply the Perfect Perf to the impression cylinder .Once applied the adhesive wll hold the rude in position.
STEP 5: Overlay the rule with the clear film tape furnishined in the spool.On the first impression the sutting or scoring adge will puncture through the tape.
Note: After securing the rule to the cylinder ,it is advisable to reduce the
pressure between the impression cylinder and gradually increase until the
desired printing and perfrating results are acquired . By increasing the
cyclinder pressure it will naturally improve the perforation but could affect the
print quality.Therefore depending on the thickness of stock being used it may
be necessary to adjust the rule height by building up the rule as suggested